Kopypastea muistiin jos joku sattuu joskus tarvitsemaan...
For the BMW sport bikes S 1000 RR and HP4 2D Debus & Diebold Meßsysteme offers professional measurement extensions for getting more out of your bike:
http://2d-datarecording.com/en/produkte/custom-packs/bmw-custom-packs/
For the BMW S1000RR are the following extensions available:
http://2d-datarecording.com/en/produkte/custom-packs/bmw-custom-packs/s1000rr-custom-pack/
S1000RR 2D logger extension box:
http://2d-datarecording.com/en/produkte/custom-packs/bmw-custom-packs/s1000rr-custom-pack/extension-box/
Datasheet:
http://2d-datarecording.com/Downloads/Datasheets/Amplifiers-and-interfaces/Pdf/IN-LSU_BMW-900.pdf
Driver:
http://2d-datarecording.com/Downloads/Treiber/atmel.zip
Art. No.: IN-LSU_BMW-900
Please note: For connecting two suspension potentiometers you need one adapter cable (One cable supports two potentiometers). Please order separately.
Art.-No. adapter cable: WL-IN_BMW-900
For calibrating sensors you need the software Race. The software is free of charge.
You can download it here:
http://2d-datarecording.com/Downloads/Setups/Race2015_Internet.EXE
With the extension box the HP race data logger can log data from two suspension potentiometers, two generic analog sensors and a lambda probe. It also controls the heating of the lambda probe. The box transmits the measurement data over the CAN-bus to the HP race data logger.
Pre-configured for direct application on the S1000RR CAN-Bus.
USB-Interface for initializing the analog sensors via a connected PC.
Supports up to two suspension sensors for front and rear, respectively.
Supports up to two generic analog sensors.
Supports one lambda probe.
Ja ois yks kysymyskin jos joku sattuis tietämään.
Eli kun mulla on -11 mopo johon flässätty RCK2, ja esim 2D dataloggeri on konffattu käyttämään 2013 liittymää, niin ecun firmware ollee vanhempi kuin 2014, eli mun tarvii kysyy noilta jotain konffisoftaa??
Downloads -Setups -section:
http://2d-datarecording.com/en/downloads/setups/
RaceKit 2015
Setup for the 2D KIT systems Trackday and Bike with firmware 2014 or newer:
http://2d-datarecording.com/Downloads/Setups/RaceKit15.EXE
For older systems please contact us:
http://2d-datarecording.com/en/kontakt/
Dataloggerin PC softasta löytyy tuollainen:
Options - HP Race Datalogger settings - Changing HP Race Datalogger device software - 06 S 1000 RR HP4 2013+ -- 2d ExtensionBox
Noista voi olla hyötyä muissakin bimmerin CAN bus hommissa.
CAN bus, MQS, 8PF/M
8 Pin Female
front view
1 2 3 4 -
- 5 6 7 8
8 Pin Male
front view
- 4 3 2 1
8 7 6 5 -
Pin Name Description Color
1 n.c. Not connected
2 n.c. Not connected
3 KL 15 Switched power supply green
4 GND Ground brown
5 CAN-L CAN Low white
6 CAN-H CAN High black
7 n.c. Not connected
8 KL 30 Permanent power supply red